These recommendations were compiled by the European Federation of Abrasive Manufacturers "FEPA" on the use of abrasive cutting and grinding wheels for metal and stone.
NovoAbrasive has been a member of FEPA since 2017.
Make sure the abrasive wheel has the EN 12413 marking and the expiration date.
Do not use wheels without the EN 12413 marking.
Be sure to read the operating instructions.
Do not throw away the instructions and review them periodically.
Check the abrasive wheel for damage or unusual spots.
Do not use a damaged wheel.
The speed indicated on the machine must not exceed the speed indicated on the disc.
Do not use a blade with a speed lower than that specified on the machine.
Type 41, Type 42, Type 27 Flanges installed correctly.
Incorrectly installed flanges type 41/type 42, type 27.
Make sure the protective cover is installed correctly.
Never remove the protective cover.
The work surface is securely fixed.
Do not cut on an unstable work surface.
Use personal protective equipment.
Never cut without protective equipment.
Use only for cutting type 41, type 42 circles.
Do not use type 41 and type 42 cutting discs for grinding.
Use only for grinding wheel type 27.
Do not use for cutting type 27 circles unless specifically stated.
Always hold the cutting wheel straight at a 90 degree angle and do not turn it while working.
Do not twist the tool while cutting.
Hold the cutting tool loosely.
Do not use excessive force when cutting.
